A:¿¿
Hope this is helpful for you. Good luck with your bracelet making!
1 Cut off a length of stretch nylon cord.
2 String the beads onto the cord until the jewelry piece is the desired length.
3 Place the two ends of the cord along side each other.
4 Cross the left side of the cord over the right side and pass the end under and then up through the center of the loop.
5 Pull the cord ends very slightly to tighten.
6 Take the cord that is now on the right side and cross over the cord that is now on the left side. Pass the end under and then up through the center of the loop.
7 Pull the cord ends to tighten the square knot. This knot must be pulled very tight to keep it tied. Trim the ends.
8 Tuck the knot as far as possible into one of the beads to conceal the knot.