The item comes with a length of stretchy cording which you should cut into 3 equal lengths. Lay the beads out side by side and all going the same direction. Thread the top hole of the beads on one cord, leaving cording at either end. You will then work the second cord through the middle hole on the beads, again leaving the extra cord at either end. Thread the last cord through the bottom hole on the beads, pull the 6 strings together at approximately the middle of the back of the bracelet and tie off. You may want to refer the photo of the bracelet in your catalog or on the website for assistance as well. We recommend working on a table or flat surface so that you are able to move the beads only slightly as you thread the second and third cords. We hope you enjoy your bracelet!
Date published: 2016-12-26