DIY Nerf Target Range

3 min read September 13, 2026 Natalie Mayhew
Share this article

Are you are hosting an Nerf Themed Birthday Party? This easy and super fun DIY Nerf® target range is perfect for the party. Have the kids shoot for points and prizes rather than pelting each other (or you!) with bullets. Fire up the Nerf blasters and the fun with a spinning target feature that means you don't have to reset the target after play. Grab the FREE downloadable Battle Signs here for your target range too!

Project Time
45 to 55 min
Difficulty
Intermediate
Step
1

Using a blade or box cutter cut two 6" x 7" holes in the 3 panel foam board. I positioned my holes near the bottom of the target board. Next, apply double-sided tape over the front of the board.

DIY Nerf Target Range step 1 part 1
DIY Nerf Target Range step 1 part 2
Step
2

Place your Design-A-Room Brick Wall Backdrop over the front of the foam board. Press and stick onto the double-sided tape. Cut the same hole out of the brick backdrop. Note: I worked in this order as cutting the board with the backdrop already stuck down results in pulling and tearing.

DIY Nerf Target Range step 2 part 1
DIY Nerf Target Range step 2 part 2
Step
3

Use camouflage (or black) duct tape to secure the edges around the holes and to secure the brick backdrop in place.

DIY Nerf Target Range step 3
Step
4

To create a spinning target, cut a length of straw to fit the back of a Nerf® Bull's-Eye Decoration (slightly above the center line). Glue the straw to the target. Then attach a coin to the bottom of the target using duct tape to lower the center of mass. The coin weight will help the target stay vertical instead of hanging horizontally.

DIY Nerf Target Range step 4 part 1
DIY Nerf Target Range step 4 part 2
DIY Nerf Target Range step 4 part 3
Step
5

Slip a Bamboo Skewer inside the straw and tape the skewer to the edge of the holes on the back of the board. This will allow the target to swivel and spin.

DIY Nerf Target Range step 5 part 1
DIY Nerf Target Range step 5 part 2
Step
6

Turn the board over so the front is facing up. Above the spinning targets glue on Camouflage Cups and additional Nerf® Bulls Eye Decorations.

The kids can get points by hitting different bulls eye targets or get instant prizes by getting a bullet in the cup.

 

DIY Nerf Target Range step 6 part 1
DIY Nerf Target Range step 6 part 2
Step
7

Once finished, stand your target up on the battlefield and get ready for the snipers to take aim. I also added Nerf® Hanging Swirl Decorations to the trees above and a pallet board sitting in front of the target range. Make sure all of your sharp shooters know the "Rules of War" before battle begins! Download the FREE printable Rules of War, Reload Station, and Battle Zone signs here!

See the complete Nerf Birthday Party as well as how to make a DIY Nerf Battle Vest and Mission Kit. Don't miss out on the recipe for Nerf Treat Pops either!

DIY Nerf Target Range step 7

Oriental Trading is your go-to source for party supplies, crafts, toys, and novelties. With over 85 years of experience, we offer a wide selection of products at unbeatable prices, making it easy to create memorable celebrations.

Learn more about us